PRODUCT

Stand Alone Mains Light Sensor with (1-10V) dimming function

DETAIL

It is used for lighting energy-saving control and constant illuminance control in office buildings, museums, commercial centers, warehouses, factories, airports, etc.
The detector automatically detects changes in the intensity of sunlight in the area in real time, and generates a 1-10VDC dimming control signal to the dimmable driver of the lamp, so as to adjust the output brightness of the lamp in real time and maintain a constant illuminance on the working surface. (The driver should have 1-10V dimming signal input interface).
220VAC power supply, and its relay output is also 220VAC, which can directly switch the lamps and lanterns
Used independently and do not need a lighting control system.
After the detector is powered on, it will automatically scan the illuminance of the detected surface continuously, and at the same time compare and calculate the detected illuminance value with the pre-set illuminance value, and automatically generate the corresponding 1-10Vdc dimming signal output to give The dimmable driver on the lamp can adjust the output brightness of the lamp in real time to maintain a constant illuminance on the working surface. (The illuminance setting value is manually selected on the photodetector, The dimming driver should have a 1-10V dimming signal input interface).
The delay time value of the detector (MP-PE1 drives the static detection function, the delay range is 10 seconds to 40 minutes; MP-PE2 does not drive the static detection function, only the constant illumination control function, no delay).
Detection range: MP-PE1 has a detection angle of 360 degrees and can detect a circular area with a diameter of 5 meters (when the detector is installed at a height of 2.4 meters). The illuminance value can be set from 0 to 1000Lux. The illuminance value of the constant illuminance detector MP-RFEIOVD can be set in the range of 2-600Lux).
Size: MP-PE1 and MP-PE2 are both 72mm in diameter and 68mm in height;
Detector MP-PIRE10VD has a diameter of 95mm and a thickness of 45mm;
The size of MP-RFEIOVD is 84mm(length)*42mm(width)*39mm(height).
MP-PE1 constant illumination control, with 1-10V dimming control signal output, with delay and motion detection function;
MP-PE2 constant illumination control, with 1-10V dimming control signal output, no motion detection function, no delay;
MP-PIRE10VD constant illumination control, 0-10V dimming control signal output, with delay and motion detection function;
MP-RFE10VD micro-wave static detection + constant illumination control, 0-10V dimming control signal output;